Mounting the Rail Assemblies

Facebooktwittergoogle_pluslinkedinFacebooktwittergoogle_pluslinkedin

Mounting the Rail Assemblies in a Square Hole Rack

  1. Position the front rail ends facing inward, and orient each end piece to sit in the square holes on the front side of the vertical rack flanges.
  2. Align each end piece to seat the pegs in the bottom hole of the first U and the top hole of the second U.
  3. Engage the back end of the rail until it fully sits on the vertical rack flange and the second tooth on the latch locks in place.
  4. Repeat these steps to position and seat the front end piece on the vertical flange.
  5. To remove the rails, pull on the latch release button on the end piece midpoint and unseat each rail.

Mounting the Rail Assemblies in a Round Hole Rack

  1. Position the front rail ends facing inward, and orient each end piece to sit in the round holes on the front side of the vertical rack flanges.
  2. Align each end piece to seat the pegs in the bottom hole of the first U and the top hole of the second U.
  3. Engage the back end of the rail until it fully seats on the vertical rack flange and the first tooth on the latch locks in place.
  4. Repeat these steps to position and seat the front end piece on the vertical flange.
  5. To remove the rails, pull on the latch release button on the end piece midpoint and unseat each rail.

Next, see Inserting the Device into the Rack.

Fortinet Technical Documentation

Fortinet Technical Documentation

Contact Fortinet Technical Documentation at techdoc@fortinet.com.
Fortinet Technical Documentation

Latest posts by Fortinet Technical Documentation (see all)

Facebooktwittergoogle_pluslinkedinFacebooktwittergoogle_pluslinkedin