FortiAntenna-M22 Installation Guide

Facebooktwittergoogle_plusredditpinterestlinkedinFacebooktwittergoogle_plusredditpinterestlinkedin

Note: The FortiAntenna-M22 is suitable for poles one to four inches (approx 2.5-10 cm) in diameter.

  1. Place item number 2 on the antenna, as illustrated in the above drawing.
    Align with the screw holes.
  2. Connect item 2 to the antenna with spring washers (11), flat washer (10), and nuts (12).
  3. Tighten the nuts at a torque of 30 in lbs (3.4 Nm).
  4. Connect item 3 to item 2 ONLY, as illustrated in the above image, with items 6, 7, 8, and 13.
    Leave screw slightly loose.
  5. Connect item 3 to item 5 as illustrated below, using items 6, 7, 8, and 13.
    Leave screw slightly loose.
  6. Attach items 4 and 5 to the pole as illustrated below, then connect them using items 6, 7, and 9.
  7. Adjust the desired angle, and fully tighten the loose screws from steps 4 & 5.
  8. Tighten the nuts at a torque of 30 in lbs (3.4 Nm).

Wall Mounting

  • Was this helpful?
  • Yes   No